Add intelligence to your ceiling boxes

Connect to a group of lamps with a total max. of 250W or connect to individual lamps. Dim everything from dimmable LEDs to incandescent light bulbs and control your light sources from the Z-Wave network.

  State-of-the-art light dimmer

The light dimmer can dim all dimmable light bulbs from 0-250 W. Even your low power LED bulbs.

Z-WaveZ-Wave controlled lamp

Connect DIMMY to a local load and control it with a Z-Wave wall switch such as MATRIX or through an app on a smartphone.

wifi  Z-Wave Plus

Based on the Z-Wave Plus 500 Series platform.


DIMMY is designed to fit into PL ceiling boxes and with its height of 12 mm on its lowest and 15 mm on its highest point, it leaves a lot of space for cables in the ceiling box.

wifi  Wireless Updates

Firmware can be updated through the Z-Wave network (OTA firmware updates).

repeater  Improves Z-Wave Network

Acts as a Z-Wave network repeater to increase reliability of the network.

DIMMY can be mounted in a ceiling box or junction box.

Use cable relief. Optionally, use the screw holes to fasten to a surface.


EAN: 5714090000158

Mounting guide
Warning! Only authorised technicians under consideration of the country-specific installation norms may do works with 230 Volt mains power. Prior to the assembly of the product, the voltage network has to be switched off.



Dimmed output (~), Neutral (N) and Line (L) must be connected according to the diagram below. Contacts with same markings (N or L) are internally connected and can be used for cable looping.

Figure A


Cable Connection/Disconnection

Use a cable, max. 2,5 mm², with a stripped length of 9-10 mm. The cable must be solid or closed with a ferrule. Connect the cable by simply pushing it into the connection terminal. Disconnect cables by pressing a slotted screwdriver with 2,5 mm slot against release button while pulling the cable (A)

Figure B


Add/remove DIMMY to the Z-Wave-network by pressing the center switch (I). The LED will now start blinking.

Figure C

Restore Factory Settings

Restore factory settings by pressing the center switch (I) for at least 10 seconds.

Technical Data
DIMENSIONS (HXWXD) 15 mm x 45 mm x 54 mm
POWER CONSUMPTION Max. 0.8 W / 0.5 W standby
LOAD 0-250 W
CLAMPS Screwless terminals 0.2 – 2.5 mm² / 24 – 14 AWG
CONTACTS 5 poles, 2 x looped line, 2 x looped neutral, 1 load
FUSE T2A (fixed)
RADIO PROTOCOL Z-Wave®: EU 868.4MHz – 500 Series
RADIO RANGE 40 m indoor / 80 m outdoor
DS/EN 50491-3:2009 or DS/EN IEC 63044-3:2018
DS/EN 60669-2-1, DS/EN60669-2-1/A1, DS/EN 60669-2-1/A12, DS/EN 60669-2-1/AC:2007, DS/EN 60669-1:2018